Publishing Service

Polishing & Checking

Journal of Zhejiang University SCIENCE A

ISSN 1673-565X(Print), 1862-1775(Online), Monthly

2011 Vol.12 No.3 P.183-189

Effect of process parameters on springback behaviour during air bending of electrogalvanised steel sheet

Durairaj Vasudevan, Rajumani Srinivasan, Palani Padmanabhan

Department of Mechanical Engineering, PSNA College of Engineering and Technology, Dindigul 624622, Tamil Nadu, India, Department of Mechanical Engineering, RVS College of Engineering and Technology, Dindigul 624005, Tamil Nadu, India, Bharath Niketan Engineering College, Andipatti 625536, Tamil Nadu, India

drdvasudevan@gmail.com, sriparam_2000@yahoo.com, ajaypalani@yahoo.co.in

Abstract: This work aims to study the springback behaviour of electrogalvanised (EG) steel sheets during the air bending process. Experiments have been conducted to analyse the influence of various parameters such as coating thickness, orientation of the sheet, punch radius, die radius, die opening, punch velocity, and punch travel on springback behaviour. It is established that the springback increases with increasing coating thickness, punch radius, punch travel, die radius, die opening, and punch velocity. The 90° orientation exhibits higher springback than 0° orientation.

Key words: Springback, Electrogalvanised (EG) steel, Air bending


Share this article to： More

Go to Contents

References:

<Show All>

Open peer comments: Debate/Discuss/Question/Opinion

<1>

Please provide your name, email address and a comment





DOI:

10.1631/jzus.A1000055

CLC number:

TQ153

Download Full Text:

Click Here

Downloaded:

4879

Clicked:

5311

Cited:

8

On-line Access:

2024-08-27

Received:

2023-10-17

Revision Accepted:

2024-05-08

Crosschecked:

2011-02-21

Journal of Zhejiang University-SCIENCE, 38 Zheda Road, Hangzhou 310027, China
Tel: +86-571-87952276; Fax: +86-571-87952331; E-mail: jzus@zju.edu.cn
Copyright © 2000~ Journal of Zhejiang University-SCIENCE