Similar articles

Abstract: In injection moulding production, the tuning of the process parameters is a challenging job, which relies heavily on the experience of skilled operators. In this paper, taking into consideration operator assessment during moulding trials, a novel intelligent model for automated tuning of process parameters is proposed. This consists of case based reasoning (CBR), empirical model (EM), and fuzzy logic (FL) methods. CBR and EM are used to imitate recall and intuitive thoughts of skilled operators, respectively, while FL is adopted to simulate the skilled operator optimization thoughts. First, CBR is used to set up the initial process parameters. If CBR fails, EM is employed to calculate the initial parameters. Next, a moulding trial is performed using the initial parameters. Then FL is adopted to optimize these parameters and correct defects repeatedly until the moulded part is found to be satisfactory. Based on the above methodologies, intelligent software was developed and embedded in the controller of an injection moulding machine. Experimental results show that the intelligent software can be effectively used in practical production, and it greatly reduces the dependence on the experience of the operators.

[1]Bozdana, A., Eyercolu, O., 2002. Development of an expert system for the determination of injection moulding parameters of thermoplastic materials: EX-PIMM. Journal of Materials Processing Technology, 128(1-3):113-122.

[2]Chen, M., Tzeng, H., Chen, Y., Chen, S., 2008. The application of fuzzy theory for the control of weld line positions in injection-molded part. ISA transactions, 47(1):119-126.

[3]Chen, W., Tai, P., Wang, M., Deng, W., Chen, C., 2008. A neural network-based approach for dynamic quality prediction in a plastic injection molding process. Expert Systems with Applications, 35(3):843-849.

[4]Chen, Z.B., Turng, L.S., 2005. A review of current developments in process and quality control for injection molding. Advances in Polymer Technology, 24(3):165-182.

[5]He, W., Zhang, Y.F., Lee, K.S., Liu, T.I., 2001. Development of a fuzzy-neuro system for parameter resetting of injection molding. Journal of manufacturing science and engineering, 123(1):110-118.

[6]Kwong, C.K., 2001. A case-based system for process design of injection moulding. International Journal of Computer Applications in Technology, 14(1-3):40-50.

[7]Mok, S.L., Kwong, C.K., Lau, W.S., 1999. Review of research in the determination of process parameters for plastic injection molding. Advances in Polymer Technology, 18(3):225-236.

[8]Shoemaker, J., 2006. Moldflow Design Guide: a Resource for Plastics Engineers. Hanser Gardner Publications, Cincinnati, OH, USA, p.13-14.

[9]Sun, Z., Finnie, G., 2005. A unified logical model for CBR-based e-commerce systems. International Journal of Intelligent Systems, 20(1):29-46.

[10]Zhang, Z.X., Sun, C.T., 1997. Neuro-Fuzzy and Soft Computing. Xi’an Jiaotong University Publishing House, Xi’an, China, p.52-56 (in Chinese).

[11]Zhao, P., Zhou, H.M., Li, Y., Li, D.Q., 2010. Process parameters optimization of injection molding using a fast strip analysis as a surrogate model. The International Journal of Advanced Manufacturing Technology, 49(9-12):949-959.