CLC number:
On-line Access: 2018-04-04
Received: 2018-03-10
Revision Accepted: 2018-03-15
Crosschecked: 2018-03-20
Cited: 0
Clicked: 2908
Mario Monzón. Biomaterials and additive manufacturing: osteochondral scaffold innovation applied to osteoarthritis (BAMOS project)[J]. Journal of Zhejiang University Science A, 2018, 19(4): 329-330.
@article{title="Biomaterials and additive manufacturing: osteochondral scaffold innovation applied to osteoarthritis (BAMOS project)",
author="Mario Monzón",
journal="Journal of Zhejiang University Science A",
volume="19",
number="4",
pages="329-330",
year="2018",
publisher="Zhejiang University Press & Springer",
doi="10.1631/jzus.A18NW001"
}
%0 Journal Article
%T Biomaterials and additive manufacturing: osteochondral scaffold innovation applied to osteoarthritis (BAMOS project)
%A Mario Monzón
%J Journal of Zhejiang University SCIENCE A
%V 19
%N 4
%P 329-330
%@ 1673-565X
%D 2018
%I Zhejiang University Press & Springer
%DOI 10.1631/jzus.A18NW001
TY - JOUR
T1 - Biomaterials and additive manufacturing: osteochondral scaffold innovation applied to osteoarthritis (BAMOS project)
A1 - Mario Monzón
J0 - Journal of Zhejiang University Science A
VL - 19
IS - 4
SP - 329
EP - 330
%@ 1673-565X
Y1 - 2018
PB - Zhejiang University Press & Springer
ER -
DOI - 10.1631/jzus.A18NW001
Abstract: Osteoarthritis (OA) is a degenerative joint disease, typified by a loss of quality of cartilage and changes in bone at the interface of a joint, resulting in pain, stiffness, and reduced mobility. “According to the World Health Organization, 40% of people over the age of 70 have OA. This joint disease affects around 0.4 billion people with patients in Europe accounting for up to 30%. The figure is set to increase with the ageing problem”. The BAMOS project particularly addresses the challenges in OA treatment by providing novel cost effective osteochondral scaffold technology for early intervention of OA to delay or avoid the joint replacement operations.
[1]Canadas RF, Pina S, Marques AP, et al., 2016. Chapter 7– cartilage and bone regeneration—how close are we to bedside? In: Translating Regenerative Medicine to the Clinic, Elsevier, London, p.89-106.
[2]Monzón M, Liu C, Ajami S, et al., 2018. Functionally graded additive manufacturing to achieve functionality specifications of osteochondral scaffolds. Bio-Design and Manufacturing, 1(1):69-75.
[3]Ondrésik M, Maia A, Fatima R, et al., 2017. Management of knee osteoarthritis. Current status and future trends. Biotechnology and Bioengineering, 114(4):717-739.
Open peer comments: Debate/Discuss/Question/Opinion
<1>