Similar articles

Abstract: Ce and Mn modified TiO₂ sorbents (ceMnTi) were prepared by a co-precipitation method, and their ability to remove elemental mercury from coal gas in a fixed bed reactor was studied. Based on results of Brunauer-Emmett-Teller (BET), X-ray diffraction (XRD), scanning electron microscope (SEM), and X-ray photoelectron spectroscopy (XPS) studies, the modification mechanisms of the ceMnTi sorbents are discussed. Mn doping improved the specific surface area and dispersion of cerium oxides on the sorbent surface, while Ce doping increased the proportion of Mn⁴⁺ in manganese oxides by a synergetic effect between manganese oxides and cerium oxides. The effects of the active component, temperature, and coal gas components on the mercury removal performance of the sorbents were investigated. The results showed that the ceMnTi sorbents exhibited high mercury removal efficiency. Ce_0.2Mn_0.1Ti adsorbed 91.55% elemental mercury from coal gas at 160 °C. H₂S and O₂ significantly improved the ability of sorbents to remove mercury. Part of the H₂S formed stable sulfates or sulfites through a series of oxidation reaction chains on the sorbent surface. HCl also improved the mercury removal performance, but reduced the promotion effect of H₂S for mercury removal when coexisting with H₂S. CO and H₂ had a minor inhibitory effect on mercury adsorption. The recycling performance of the sorbents was investigated by thermal regeneration. The thermal decomposition of the used sorbents indicated that mercury compounds were present mainly in the form of HgO and HgS, and higher temperature was beneficial for regeneration. The formation of sulfates and sulfites in the presence of H₂S led to a decrease in mercury removal efficiency.

CeMnTi吸附剂脱除煤气汞及再生性能的研究

[1]Andreu N, Flahaut D, Dedryvère R, et al., 2015. XPS investigation of surface reactivity of electrode materials: effect of the transition metal. ACS Applied Materials & Interfaces, 7(12):6629-6636.

[2]Cheah S, Carpenter DL, Magrini-Bair KA, 2009. Review of mid- to high-temperature sulfur sorbents for desulfurization of biomass- and coal-derived syngas. Energy & Fuels, 23(11):5291-5307.

[3]Ding ZY, Li LX, Wade D, et al., 1998. Supercritical water oxidation of NH₃ over a MnO₂/CeO₂ catalyst. Industrial & Engineering Chemistry Research, 37(5):1707-1716.

[4]Dong J, Xu ZH, Kuznicki SM, 2009. Mercury removal from flue gases by novel regenerable magnetic nanocomposite sorbents. Environmental Science & Technology, 43(9):3266-3271.

[5]Gao X, Jiang Y, Zhong Y, et al., 2010. The activity and characterization of CeO₂-TiO₂ catalysts prepared by the sol-gel method for selective catalytic reduction of NO with NH₃. Journal of Hazardous Materials, 174(1-3):734-739.

[6]Granite EJ, Pennline HW, Hargis RA, 2000. Novel sorbents for mercury removal from flue gas. Industrial & Engineering Chemistry Research, 39(4):1020-1029.

[7]He C, Shen BX, Chen JH, et al., 2014. Adsorption and oxidation of elemental mercury over Ce-MnO_x/Ti-PILCs. Environmental Science & Technology, 48(14):7891-7898.

[8]Hou WH, Zhou JS, Qi P, et al., 2014. Effect of H₂S/HCl on the removal of elemental mercury in syngas over CeO₂-TiO₂. Chemical Engineering Journal, 241:131-137.

[9]IEA (International Energy Agency), 2019. World Energy Outlook 2019. https://www.iea.org/reports/world-energy-outlook-2019

[10]Jampaiah D, Ippolito SJ, Sabri YM, et al., 2016. Ceria-zirconia modified MnO_x catalysts for gaseous elemental mercury oxidation and adsorption. Catalysis Science & Technology, 6(6):1792-1803.

[11]Ji L, Sreekanth PM, Smirniotis PG, et al., 2008. Manganese oxide/titania materials for removal of NO_x and elemental mercury from flue gas. Energy & Fuels, 22(4):2299-2306.

[12]Kobayashi M, Flytzani-Stephanopoulos M, 2002. Reduction and sulfidation kinetics of cerium oxide and Cu-modified cerium oxide. Industrial & Engineering Chemistry Research, 41(13):3115-3123.

[13]Li HL, Wu CY, Li Y, et al., 2011. CeO₂-TiO₂ catalysts for catalytic oxidation of elemental mercury in low-rank coal combustion flue gas. Environmental Science & Technology, 45(17):7394-7400.

[14]Li JF, Yan NQ, Qu Z, et al., 2010. Catalytic oxidation of elemental mercury over the modified catalyst Mn/α-Al₂O₃ at lower temperatures. Environmental Science & Technology, 44(1):426-431.

[15]Li XQ, Zhou JS, Zhou QX, et al., 2018. Removal of elemental mercury using titania sorbents loaded with cobalt ceria oxides from syngas. New Journal of Chemistry, 42(15):12503-12510.

[16]Liu YX, Adewuyi YG, 2016. A review on removal of elemental mercury from flue gas using advanced oxidation process: chemistry and process. Chemical Engineering Research and Design, 112:199-250.

[17]Lu DY, Granatstein DL, Rose DJ, 2004. Study of mercury speciation from simulated coal gasification. Industrial & Engineering Chemistry Research, 43(17):5400-5404.

[18]Lu H, Greenwood P, Chen TS, et al., 2012. The separate production of H₂S from the thermal reaction of hydrocarbons with magnesium sulfate and sulfur: implications for thermal sulfate reduction. Applied Geochemistry, 27(1):96-105.

[19]Matsumoto S, 2004. Recent advances in automobile exhaust catalysts. Catalysis Today, 90(3-4):183-190.

[20]Mullins DR, Overbury SH, Huntley DR, 1998. Electron spectroscopy of single crystal and polycrystalline cerium oxide surfaces. Surface Science, 409(2):307-319.

[21]Qi GS, Yang RT, 2004. Characterization and FTIR studies of MnO_x-CeO₂ catalyst for low-temperature selective catalytic reduction of NO with NH₃. The Journal of Physical Chemistry B, 108(40):15738-15747.

[22]Rallo M, Fuente-Cuesta A, Lopez-Anton MA, et al., 2014. Speciation of Hg retained in gasification biomass chars by temperature-programmed decomposition. Fuel Processing Technology, 126:1-4.

[23]Reddy BM, Khan A, 2005. Nanosized CeO₂-SiO₂, CeO₂-TiO₂, and CeO₂-ZrO₂ mixed oxides: influence of supporting oxide on thermal stability and oxygen storage properties of ceria. Catalysis Surveys from Asia, 9(3):155-171.

[24]Reddy BM, Khan A, Yamada Y, et al., 2003. Structural characterization of CeO₂-TiO₂ and V₂O₅/CeO₂-TiO₂ catalysts by Raman and XPS techniques. The Journal of Physical Chemistry B, 107(22):5162-5167.

[25]Rumayor M, Fernandez-Miranda N, Lopez-Anton MA, et al., 2015. Application of mercury temperature programmed desorption (HgTPD) to ascertain mercury/char interactions. Fuel Processing Technology, 132:9-14.

[26]Shen BX, Ma HQ, Yao Y, 2012. Mn-CeO_x/Ti-PILCs for selective catalytic reduction of NO with NH₃ at low temperature. Journal of Environmental Sciences, 24(3):499-506.

[27]Wang FC, Yu GS, Gong X, et al., 2009. Research and development of large-scale coal gasification technology. Chemical Industry and Engineering Progress, 28(2):173-180.

[28]Wu SJ, Oya N, Ozaki M, et al., 2007. Development of iron oxide sorbents for Hg⁰ removal from coal derived fuel gas: sulfidation characteristics of iron oxide sorbents and activity for COS formation during Hg⁰ removal. Fuel, 86(17-18):2857-2863.

[29]Wu X, Duan YF, Yao T, et al., 2019. Mercury removal performance and SO₂ resistance of Ce-Mn/TiO₂ sorbent. China Environmental Science, 39(6):2336-2343.

[30]Yang ZQ, Li HL, Liao C, et al., 2018. Magnetic rattle-type Fe₃O₄@CuS nanoparticles as recyclable sorbents for mercury capture from coal combustion flue gas. ACS Applied Nano Materials, 1(9):4726-4736.

[31]You SL, Zhou JS, Hou WH, et al., 2014. Factors influencing the removal of elemental mercury by Mn-AC sorbent in syngas. Journal of Fuel Chemistry and Technology, 42(11):1324-1331.

[32]Yu XQ, Bao JJ, Jiang XX, et al., 2015. Performance and mechanism of catalytic oxidation for mercury by Mn-doped TiO₂ catalysts in flue gas. Proceedings of the CSEE, 35(13):3331-3337.

[33]Yuan B, Mao XZ, Wang Z, et al., 2020. Radical-induced oxidation removal of multi-air-pollutant: a critical review. Journal of Hazardous Materials, 383:121162.

[34]Zeng XB, Xu Y, Zhang B, et al., 2017. Elemental mercury adsorption and regeneration performance of sorbents FeMnO_x enhanced via non-thermal plasma. Chemical Engineering Journal, 309:503-512.

[35]Zeng Y, Zhang S, Groves FR, et al., 1999. High temperature gas desulfurization with elemental sulfur production. Chemical Engineering Science, 54(15-16):3007-3017.

[36]Zhang AC, Zheng WW, Song J, et al., 2014. Cobalt manganese oxides modified titania catalysts for oxidation of elemental mercury at low flue gas temperature. Chemical Engineering Journal, 236:29-38.

[37]Zhang H, Zhao JT, Fang YT, et al., 2012. Catalytic oxidation and stabilized adsorption of elemental mercury from coal-derived fuel gas. Energy & Fuels, 26(3):1629-1637.

[38]Zhang HW, Chen JY, Zhao K, et al., 2016. Removal of vapor-phase elemental mercury from simulated syngas using semi-coke modified by Mn/Ce doping. Journal of Fuel Chemistry and Technology, 44(4):394-400.

[39]Zhang SB, Zhao YC, Díaz-Somoano M, et al., 2018. Synergistic mercury removal over the CeMnO₃ perovskite structure oxide as a selective catalytic reduction catalyst from coal combustion flue gas. Energy & Fuels, 32(11):11785-11795.

[40]Zheng JM, Zhou JS, Luo ZY, et al., 2012. Impact of individual acid flue gas components on mercury capture by heat-treated activated carbon. Journal of Zhejiang University-SCIENCE A (Applied Physics & Engineering), 13(9):700-708.

[41]Zhou JS, Hou WH, Qi P, et al., 2013. CeO₂-TiO₂ sorbents for the removal of elemental mercury from syngas. Environmental Science & Technology, 47(17):10056-10062.

[42]Zhu YC, Han XJ, Huang ZG, et al., 2018. Superior activity of CeO₂ modified V₂O₅/AC catalyst for mercury removal at low temperature. Chemical Engineering Journal, 337: 741-749.

[43]Zhuang K, Qiu J, Xu BL, et al., 2012. Promotional effect of cerium oxide on the catalytic properties of Ce-Mn-Ti-O catalysts for selective catalytic reduction of NO. Acta Physico-Chimica Sinica, 28(3):681-685.