Abstract: Partial shading and mismatch conditions among the series-connected modules/sub-modules suffer from a nonconvex power curve with multiple local maxima and decreased peak power for the whole string. Energy transfer between the sub-modules brings them to the same operating voltage, and this collective operation produces a convex power curve, which results in increased peak power for the string. The proposed topology benefits from the switched-capacitor (SC) converter concept and is an application for sub-module-level power balancing with some novelties, including stopping the switching in absence of shading, string-level extension, and a reduced number of power electronics components as compared to those in the literature. Reduction in the number of power electronics components is realized by the fact that two sub-modules share one SC converter. This leads to reduced power electronics losses as well as less cost and volume of the converter circuit. Insertion loss analysis of the topology is presented. The proposed topology is simulated in the PSpice environment, and a prototype is built for experimental verification. Both simulation and experimental results confirm the loss analysis. This proves that with the proposed topology it is possible to extract almost all the power available on the partially shaded string and transfer it to the load side.

一种新型的部分遮挡和非匹配条件下最大功率点跟踪光伏子模块级功率平衡拓扑结构

[1]Chang, A.H., Leeb, S.B., 2014. Differential diffusion charge redistribution for photovoltaic cell-level power balancing. Int. Conf. on Renewable Energy Research and Application, p.576-582.

[2]Chang, A.H., Avestruz, A.T., Leeb, S.B., 2014. Capacitor-less photovoltaic (PV) cell-level power balancing using diffusion charge redistribution. 29th Annual IEEE Applied Power Electronics Conf. and Exposition, p.712-720.

[3]Chang, A.H., Avestruz, A.T., Leeb, S.B., 2015. Capacitor-less photovoltaic cell-level power balancing using diffusion charge redistribution. IEEE Trans. Power Electron., 30(2):537-546.

[4]Choi, B., Clement, D., Maksimovic, D., 2014. A CMOS controller for submodule integrated converters in photovoltaic systems. IEEE 15th Workshop on Control and Modeling for Power Electronics, p.1-6.

[5]Giral, R., Ramos-Paja, C.A., Gonzalez, D., et al., 2010. Minimizing the effects of shadowing in a PV module by means of active voltage sharing. IEEE Int. Conf. on Industrial Technology, p.943-948.

[6]Gokdag, M., Akbaba, M., 2014. Symmetric ladder connection design using diffusion charge redistribution for solar cell-level MPPT with reduced insertion loss. SOLARTR Conf. & Exhibition, p.720-726.

[7]Kerekes, T., 2009. Analysis and Modeling of Transformerless Photovoltaic Inverter Systems. PhD Thesis, Aalborg University, Denmark.

[8]Kesarwani, K., Stauth, J.T., 2012. A comparative theoretical analysis of distributed ladder converters for sub-module PV energy optimization. IEEE 13th Workshop on Control and Modeling for Power Electronics, p.1-6.

[9]Kim, K.A., Shenoy, P.S., Krein, P.T., 2012. Photovoltaic differential power converter trade-offs as a consequence of panel variation. IEEE 13th Workshop on Control and Modeling for Power Electronics, p.1-7.

[10]Levron, Y., Clement, D., Maksimovic, D., et al., 2013. Nonlinear control design for the photovoltaic isolated-port architecture with submodule integrated converters. IEEE Energy Conversion Congress and Exposition, p.2398- 2405.

[11]Levron, Y., Clement, D., Choi, B., et al., 2014. Control of submodule integrated converters in the isolated-port differential power-processing photovoltaic architecture. IEEE J. Emerg. Sel. Top. Power Electron., 2(4):821-832.

[12]Olalla, C., Clement, D., Choi, B.S., et al., 2013. A branch and bound algorithm for high-granularity PV simulations with power limited SubMICs. IEEE 14th Workshop on Control and Modeling for Power Electronics, p.1-6.

[13]Olalla, C., Deline, C., Maksimovic, D., 2014a. Performance of mismatched PV systems with submodule integrated converters. IEEE J. Photovolt., 4(1):396-404.

[14]Olalla, C., Deline, C., Maksimovic, D., 2014b. Modeling and simulation of conventionally wired photovoltaic systems based on differential power processing SubMIC- enhanced PV modules. IEEE 15th Workshop on Control and Modeling for Power Electronics, p.1-9.

[15]Olalla, C., Deline, C., Clement, D., et al., 2015. Performance of power-limited differential power processing architectures in mismatched PV systems. IEEE Trans. Power Electron., 30(2):618-631.

[16]Pilawa-Podgurski, R.C.N., Perreault, D.J., 2013. Submodule integrated distributed maximum power point tracking for solar photovoltaic applications. IEEE Trans. Power Electron., 28(6):2957-2967.

[17]Qin, S.B., Pilawa-Podgurski, R.C.N., 2013. Sub-module differential power processing for photovoltaic applications. 28th Annual IEEE Applied Power Electronics Conf. and Exposition, p.101-108.

[18]Qin, S.B., Cady, S.T., Domínguez-García, A.D., et al., 2013. A distributed approach to MPPT for PV sub-module differential power processing. IEEE Energy Conversion Congress and Exposition, p.2778-2785.

[19]Seeman, M.D., Sanders, S.R., 2006. Analysis and optimization of switched-capacitor DC-DC converters. IEEE Workshops on Computers in Power Electronics, p.216-224.

[20]Shenoy, P.S., Johnson, B., Krein, P.T., 2012a. Differential power processing architecture for increased energy production and reliability of photovoltaic systems. 27th Annual IEEE Applied Power Electronics Conf. and Exposition, p.1987-1994.

[21]Shenoy, P.S., Kim, K.A., Krein, P.T., 2012b. Comparative analysis of differential power conversion architectures and controls for solar photovoltaics. IEEE 13th Workshop on Control and Modeling for Power Electronics, p.1-7.

[22]Shenoy, P.S., Kim, K.A., Johnson, B.B., et al., 2013. Differential power processing for increased energy production and reliability of photovoltaic systems. IEEE Trans. Power Electron., 28(6):2968-2979.

[23]Stauth, J.T., Kesarwani, K., Schaef, C., 2012a. A distributed photovoltaic energy optimization system based on a sub-module resonant switched-capacitor implementation. 15th Int. Power Electronics and Motion Control Conf., p.1-6.

[24]Stauth, J.T., Seeman, M.D., Kesarwani, K., 2012b. A resonant switched-capacitor IC and embedded system for sub-module photovoltaic power management. IEEE J. Solid-State Circ., 47(12):3043-3054.

[25]Stauth, J.T., Seeman, M.D., Kesarwani, K., 2013. Resonant switched-capacitor converters for sub-module distributed photovoltaic power management. IEEE Trans. Power Electron., 28(3):1189-1198.