Similar articles

Abstract: flame stabilization in a kerosene-fueled scramjet combustor was investigated experimentally through Schlieren, flame luminosity, and wall pressure measurement, aiming to obtain better insight into combustion characteristics. Experiments were conducted in a direct-connected supersonic combustion facility with inflow conditions of Mach number 2.0, stagnation pressure 0.82 MPa, and temperature 950 K, simulating the flight condition of Mach number 4.0. Results revealed that kerosene was able to be ignited when the equivalence ratio of pilot hydrogen reached 0.080, but was unsuccessful when the equivalence ratio was 0.040. Once ignited, the intense combustion induced high back pressure forcing the flame to spread into the isolator. The pilot flame invariably appeared in the cavity shear layer and attached to the cavity ramp under different equivalence ratios of pilot hydrogen. With the mass flux of pilot hydrogen increased, the kerosene flame located near the cavity ramp was asymmetrical and unstable since it propagated upstream repeatedly. Therefore, the kerosene could be ignited by a suitable equivalence ratio of continuous pilot hydrogen, potentially accompanied with unstable combustion.

先锋氢引燃煤油的超燃燃烧室火焰稳定性研究

[1]Chang EWKC, Yang SM, Park G, et al., 2018. Ethylene flame-holding in double ramp flows. Aerospace Science and Technology, 80:413-423.

[2]Chang JT, Zhang JL, Bao W, et al., 2018. Research progress on strut-equipped supersonic combustors for scramjet application. Progress in Aerospace Sciences, 103:1-30.

[3]Feng R, Li J, Wu Y, et al., 2018. Experimental investigation on gliding arc discharge plasma ignition and flame stabilization in scramjet combustor. Aerospace Science and Technology, 79:145-153.

[4]Huang W, Yan L, 2013. Progress in research on mixing techniques for transverse injection flow fields in supersonic crossflows. Journal of Zhejiang University-SCIENCE A (Applied Physics & Engineering), 14(8):554-564.

[5]Huang W, Li MH, Ding F, et al., 2016. Supersonic mixing augmentation mechanism induced by a wall-mounted cavity configuration. Journal of Zhejiang University-SCIENCE A (Applied Physics & Engineering), 17(1):45-53.

[6]Kim K, Park G, Jin S, 2019. Flameholding characteristics of ethylene-fueled model scramjet in shock tunnel. Acta Astronautica, 161:446-464.

[7]Liao L, Yan L, Huang W, et al., 2018. Mode transition process in a typical strut-based scramjet combustor based on a parametric study. Journal of Zhejiang University-SCIENCE A (Applied Physics & Engineering), 19(6):431-451.

[8]Niioka T, Terada K, Kobayashi H, et al., 1995. Flame stabilization characteristics of strut divided into two parts in supersonic airflow. Journal of Propulsion and Power, 11(1):112-116.

[9]Sun MB, Wang ZG, Liang JH, et al., 2008. Flame characteristics in supersonic combustor with hydrogen injection upstream of cavity flameholder. Journal of Propulsion and Power, 24(4):688-696.

[10]Sun MB, Gong C, Zhang SP, et al., 2012. Spark ignition process in a scramjet combustor fueled by hydrogen and equipped with multi-cavities at Mach 4 flight condition. Experimental Thermal and Fluid Science, 43:90-96.

[11]Wang HB, Wang ZG, Sun MB, et al., 2013. Combustion modes of hydrogen jet combustion in a cavity-based supersonic combustor. International Journal of Hydrogen Energy, 38(27):12078-12089.

[12]Wang YH, Song WY, 2019. Experimental investigation of influence factors on flame holding in a supersonic combustor. Aerospace Science and Technology, 85:180-186.

[13]Wang YH, Song YW, Fu Q, et al., 2017. Experimental study of vitiation effects on hydrogen/kerosene fueled supersonic combustor. Aerospace Science and Technology, 60:108-114.

[14]Wang ZG, Sun MB, Wang HB, et al., 2015. Mixing-related low frequency oscillation of combustion in an ethylene-fueled supersonic combustor. Proceedings of the Combustion Institute, 35(2):2137-2144.

[15]Zhang JL, Chang JT, Shi W, et al., 2018. Combustion stabilizations in a liquid kerosene fueled supersonic combustor equipped with an integrated pilot strut. Aerospace Science and Technology, 77:83-91.

[16]Zhang LW, Choi JY, Yang V, 2015. Supersonic combustion and flame stabilization of coflow ethylene and air with splitter plate. Journal of Propulsion and Power, 31(5):1242-1255.

[17]Zhao GY, Sun MB, Wu JS, et al., 2019. Investigation of flame flashback phenomenon in a supersonic crossflow with ethylene injection upstream of cavity flameholder. Aerospace Science and Technology, 87:190-206.

[18]Zhu SH, Xu X, Yang QC, et al., 2018. Intermittent back-flash phenomenon of supersonic combustion in the staged-strut scramjet engine. Aerospace Science and Technology, 79: 70-74.