Similar articles

Abstract: internally-cooled dehumidifiers are efficient liquid desiccant dehumidifiers, whose performance is mainly determined by the device structure and operating conditions. Based on energy and mass conservation in the air, solution, and cooling water in the device, mathematical models are built and their theoretical performance is simulated and analyzed in this paper. A novel measure of dehumidification efficiency is introduced to evaluate the performance of internally-cooled dehumidifiers, in which the equilibrium humidity ratio of the inlet solution is calculated according to the minimum temperature in the inlet solution and the cooling water. Numerical simulations show that a counter flow between air and solution is always the most efficient, followed by cross flow, and parallel flow is the least efficient. Cooling water with the same flow direction as the solution performs better than that with a counter flow, with approximately a 5% improvement in efficiency. Compared with CaCl₂, the dehumidification efficiency of a LiCl solution is greater by 60%, while its exergy efficiency is less by 16%. dehumidification efficiency can be improved with the number of air-solution heat transfer units (NTU_a-s) increasing, and reduced with the air mass flow rate raised. With NTU_a-s increasing, exergy efficiency can be improved, and an increase in mass flow rate of cooling water results in a decrease of efficiency. Higher solution concentration and lower inlet temperature of solution and air can achieve both higher dehumidification efficiency and exergy efficiency.

The paper provides a robust analysis and evaluation of ICDs systems. The paper is well written and well presented. The paper provide novel methodology to deal with similar configurations and provide tools for optimization of these systems.

使用LiCl和CaCl₂溶液的内冷型溶液除湿器效率对比和性能分析

[1]Al-Farayedhi AA, Gandhidasan P, Al-Mutairi MA, 2002. Evaluation of heat and mass transfer coefficients in a gauze-type structured packing air dehumidifier operating with liquid desiccant. International Journal of Refrigeration, 25(3):330-339.

[2]Bansal P, Jain S, Moon C, 2011. Performance comparison of an adiabatic and an internally cooled structured packed-bed dehumidifier. Applied Thermal Engineering, 31(1):14-19.

[3]Bassuoni MM, 2011. An experimental study of structured packing dehumidifier/regenerator operating with liquid desiccant. Energy, 36(5):2628-2638.

[4]Chang XM, Liu XH, Jiang Y, 2007. Performance numerical analysis on an internally-cooled liquid desiccant dehumidifier. Proceeding IBPSA International Building Performance Simulation Association Conference.

[5]Chang XM, Liu XH, Jiang Y, 2009. Research on the heat and mass transfer performance and flow-pattern comparison of the internally-cooled liquid desiccant dehumidifiers. Acta Energiae Solaris Sinica, 30(2):170-176 (in Chinese).

[6]Chung TW, Wu WY, Yan WJ, et al., 1995. Efficiency of a liquid desiccant dehumidification system regenerated by using solar collectors/regenerators with photovoltaic fans. Separation Science and Technology, 30(6):1039-1045.

[7]Conde MR, 2004. Properties of aqueous solutions of lithium and calcium chlorides: formulations for use in air conditioning equipment design. International Journal of Thermal Sciences, 43(4):367-382.

[8]Dai YJ, Zhang HF, 2004. Numerical simulation and theoretical analysis of heat and mass transfer in a cross flow liquid desiccant air dehumidifier packed with honeycomb paper. Energy Conversion and Management, 45(9-10):1343-1356.

[9]Ding T, Huang ZD, Zhao WJ, et al., 2010. Dehumidification and regeneration efficiency of the mixed salt solution in the solar dehumidification system. Transactions of the Chinese Society of Agricultural Engineering, 26(2):295-299 (in Chinese).

[10]Fazilati MA, Alemrajabi AA, Sedaghat A, 2017. Liquid desiccant air conditioning system with natural convection. Applied Thermal Engineering, 115:305-314.

[11]Gandhidasan P, 2004. A simplified model for air dehumidification with liquid desiccant. Solar Energy, 76(4):409-416.

[12]Gao WZ, Shi YR, Cheng YP, et al., 2013. Experimental study on partially internally cooled dehumidification in liquid desiccant air conditioning system. Energy and Buildings, 61:202-209.

[13]Gonçalves P, Angrisani G, Sasso M, et al., 2014. Exergetic analysis of a desiccant cooling system: searching for performance improvement opportunities. International Journal of Energy Research, 38(6):714-727.

[14]Hürdoğan E, Buyükalaca O, Hepbasli A, et al., 2011. Exergetic modeling and experimental performance assessment of a novel desiccant cooling system. Energy and Buildings, 43(6):1489-1498.

[15]Jain S, Dhar PL, Kaushik SC, 2000. Experimental studies on the dehumidifier and regenerator of a liquid desiccant cooling system. Applied Thermal Engineering, 20(3):253-267.

[16]Jain S, Bansal PK, 2007. Performance analysis of liquid desiccant dehumidification systems. International Journal of Refrigeration, 30(5):861-872.

[17]Jain S, Tripathi S, Das RS, 2011. Experimental performance of a liquid desiccant dehumidification system under tropical climates. Energy Conversion and Management, 52(6):2461-2466.

[18]Koronaki IP, Christodoulaki RI, Papaefthimiou VD, et al., 2013. Thermodynamic analysis of a counter flow adiabatic dehumidifier with different liquid desiccant materials. Applied Thermal Engineering, 50(1):361-373.

[19]Liu J, Zhang T, Liu XH, et al., 2015. Experimental analysis of an internally-cooled/heated liquid desiccant dehumidifier/ regenerator made of thermally conductive plastic. Energy and Buildings, 99:75-86.

[20]Liu J, Liu XH, Zhang T, 2016. Performance comparison of three typical types of internally-cooled liquid desiccant dehumidifiers. Building and Environment, 103:134-145.

[21]Liu XH, Chang XM, Xia JJ, et al., 2009. Performance analysis on the internally cooled dehumidifier using liquid desiccant. Building and Environment, 44(2):299-308.

[22]Longo GA, Gasparella A, 2005. Experimental and theoretical analysis of heat and mass transfer in a packed column dehumidifier/regenerator with liquid desiccant. International Journal of Heat and Mass Transfer, 48(25-26):5240-5254.

[23]Lowenstein A, 2008. Review of liquid desiccant technology for HVAC applications. HVAC&R Research, 14(6):819-839.

[24]Luo YM, Shao SQ, Xu HB, et al., 2014. Experimental and theoretical research of a fin-tube type internally-cooled liquid desiccant dehumidifier. Applied Energy, 133:127-134.

[25]Mei L, Dai YJ, 2008. A technical review on use of liquid-desiccant dehumidification for air-conditioning application. Renewable and Sustainable Energy Reviews, 12(3):662-689.

[26]Oberg V, Goswami DY, 1998. Experimental study of the heat and mass transfer in a packed bed liquid desiccant air dehumidifier. Journal of Solar Energy Engineering, 120(4):289-297.

[27]Peng DG, Zhang XS, 2016. Dehumidification efficiency model for solar thermal regeneration system. Transactions of the Chinese Society of Agricultural Engineering, 32(1):206-211 (in Chinese).

[28]Peng DG, Zhou JM, Luo DT, 2017. Exergy analysis of a liquid desiccant evaporative cooling system. International Journal of Refrigeration, 82:495-508.

[29]Qi RH, Lu L, 2014. Energy consumption and optimization of internally cooled/heated liquid desiccant air-conditioning system: a case study in Hong Kong. Energy, 73:801-808.

[30]Qi RH, Lu L, Yang HX, 2013. Development of simplified prediction model for internally cooled/heated liquid desiccant dehumidification system. Energy and Buildings, 59:133-142.

[31]Ren CQ, Tu M, Wang HH, 2007. An analytical model for heat and mass transfer processes in internally cooled or heated liquid desiccant-air contact units. International Journal of Heat and Mass Transfer, 50(17-18):3545-3555.

[32]Tu M, Ren CQ, Tang GF, et al., 2010. Performance comparison between two novel configurations of liquid desiccant air-conditioning system. Building and Environment, 45(12):2808-2816.

[33]Turgut OE, Coban MT, 2016. Experimental and numerical investigation on the performance of an internally cooled dehumidifier. Heat and Mass Transfer, 52(12):2707-2722.

[34]Uçkan I, Yılmaz T, Hürdoğan E, et al., 2014. Exergy analysis of a novel configuration of desiccant based evaporative air conditioning system. Energy Conversion and Management, 84:524-532.

[35]Wang L, Li NP, Zhao BW, 2010. Exergy performance and thermodynamic properties of the ideal liquid desiccant dehumidification system. Energy and Buildings, 42(12):2437-2444.

[36]Xiao F, Ge GM, Niu XF, 2011. Control performance of a dedicated outdoor air system adopting liquid desiccant dehumidification. Applied Energy, 88(1):143-149.

[37]Xiong ZQ, Dai YJ, Wang RZ, 2010. Exergy analysis of liquid desiccant dehumidification system. International Journal of Green Energy, 7(3):241-262.

[38]Yang ZL, Lian ZW, 2014. Analysis of influencing factors on performance of the LDAC system based on the concept of ideal dehumidification efficiency. Journal of Shanghai Jiaotong University, 48(6):821-826 (in Chinese).

[39]Yin YG, Zhang XS, Wang G, et al., 2008. Experimental study on a new internally cooled/heated dehumidifier/ regenerator of liquid desiccant systems. International Journal of Refrigeration, 31(5):857-866.

[40]Yin YG, Qian JF, Zhang XS, 2014. Recent advancements in liquid desiccant dehumidification technology. Renewable and Sustainable Energy Reviews, 31:38-52.

[41]Zhang L, Hihara E, Matsuoka F, et al., 2010. Experimental analysis of mass transfer in adiabatic structured packing dehumidifier/regenerator with liquid desiccant. International Journal of Heat and Mass Transfer, 53(13-14):2856-2863.

[42]Zhang T, Liu XH, Jiang JJ, et al., 2013. Experimental analysis of an internally-cooled liquid desiccant dehumidifier. Building and Environment, 63:1-10.

[43]Zhang T, Liu XH, Liu J, et al., 2017. Exergy and entransy analyses in air-conditioning system. Part 2-humid air handling process. Energy and Buildings, 139:10-21.

[44]Zhu MS, 1988. Exergy Analysis of Energy Systems. Tsinghua University Press, Beijing, China (in Chinese).