Similar articles

Abstract: A combustion-powered actuator has been proposed in our previous work (Wang et al., 2015), and it has shown great power hopping ability. To explore the hopping process and output performance of the actuator, the model of an actuator driving the hopping process is investigated through theoretical analysis and experimental validation. Firstly, the structure of the actuator and hopping process are described briefly, and the dynamic models of the process are constructed. Secondly, the thermodynamic model of the actuator is established by the Wiebe heat release function and the input energy density is computed by Chemkin for when propane and nitrous oxide with different equivalence ratios are injected into the chamber. Thus, the thermodynamic model is obtained by integrating dynamic and thermodynamic equations. After that, a few output performance parameters are identified to assess system performance. Lastly, the experimental rig of the combustion actuator is set up to test the displacement and pressure of the actuator driven hopping process. By solving the thermodynamic equations, the post-combustion pressure, the displacement and the velocity varying with time are computed, and are compared with the test results, indicating that the computational results match the experimental test well. At the end of the stroke, the velocities of the experiment and simulation are 6.5 m/s and 6.99 m/s, respectively. The hopping results are compared with the simulation when different pressures under equivalence ratio of 1 are injected, and the maximum and minimum deviations are 14.45% and 1.83%, respectively.

燃爆弹跳驱动器仿真与试验研究

[1]Ackerman, E., 2012. Boston dynamics sand flea robot demonstrates astonishing jumping skills. IEEE Spectrum Robotics Blog. http://spectrum.ieee.org/automaton/robotics/military-robots/boston-dynamics-sand-flea-demonstrates-astonishing-jumping-skills [Accessed on Mar. 28, 2016]

[2]Burdick, J., Fiorini, P., 2003. Minimalist jumping robots for celestial exploration. The International Journal of Robotics Research, 22(7-8):653-674.

[3]Fischer, G.J., 2005. Wheeled hopping mobility. European Symposium on Optics and Photonics for Defence and Security, No. 59860H.

[4]Fite, K.B., Goldfarb, M., 2006. Design and energetic characterization of a proportional-injector monopropellant-powered actuator. IEEE/ASME Transactions on Mechatronics, 11(2):196-204.

[5]Ghojel, J.I., 2010. Review of the development and applications of the Wiebe function: a tribute to the contribution of Ivan Wiebe to engine research. International Journal of Engine Research, 11(4):297-312.

[6]Jia, B., Tian, G., Feng, H., et al., 2015. An experimental investigation into the starting process of free-piston engine generator. Applied Energy, 157:798-804.

[7]Kee, R.J., Rupley, F.M., Miller, J.A., et al., 2006. CHEMKIN Release 4.1, Reaction Design. San Diego, California, USA.

[8]Kim, J., Bae, C., Kim, G., 2013. Simulation on the effect of the combustion parameters on the piston dynamics and engine performance using the Wiebe function in a free piston engine. Applied Energy, 107:446-455.

[9]Kovac, M., Fuchs, M., Guignard, A., et al., 2008. A miniature 7g jumping robot. IEEE International Conference on Robotics and Automation, p.373-378.

[10]Li, Q.F., Xiao, J., Huang, Z., 2008. Simulation of a two-stroke free-piston engine for electrical power generation. Energy & Fuels, 22(5):3443-3449.

[11]Li, Q.F., Xiao, J., Huang, Z., 2009. Flat-type permanent magnet linear alternator: a suitable device for a free piston linear alternator. Journal of Zhejiang University-SCIENCE A, 10(3):345-352.

[12]Loepfe, M., Schumacher, C.M., Lustenberger, U.B., et al., 2015. An untethered, jumping roly-poly soft robot driven by combustion. Soft Robotics, 2(1):33-41.

[13]Luan, Y.G., Wang, H.M., Zhao, D.B., et al., 2015. Analysis and experiment of combustion powered linear actuator for hopping. Robot, 37(4):499-505 (in Chinese).

[14]Luan, Y.G., Wang, H.M., Zhao, D.B., et al., 2016. Hopping ability of gas fuel power hopping robot on different grounds. Journal of Beijing University of Aeronautics and Astronautics, 42(5):984-991 (in Chinese).

[15]Mikalsen, R., Roskilly, A.P., 2007. A review of free-piston engine history and applications. Applied Thermal Engineering, 27(14-15):2339-2352.

[16]Mikalsen, R., Roskilly, A.P., 2009. Coupled dynamic-multidimensional modelling of free-piston engine combustion. Applied Energy, 86(1):89-95.

[17]Nguyen, Q.V., Park, H.C., 2012. Design and demonstration of a locust-like jumping mechanism for small-scale robots. Journal of Bionic Engineering, 9(3):271-281.

[18]Powell, O.A., Papas, P., Dreyer, C.B., 2010. Hydrogen-and C1–C3 hydrocarbon-nitrous oxide kinetics in freely propagating and burner-stabilized flames, shock tubes, and flow reactors. Combustion Science and Technology, 182(3):252-283.

[19]Rakopoulos, C.D., Kosmadakis, G.M., Demuynck, J., et al., 2011. A combined experimental and numerical study of thermal processes, performance and nitric oxide emissions in a hydrogen-fueled spark-ignition engine. International Journal of Hydrogen Energy, 36(8):5163-5180.

[20]Spletzer, B.L., Fisher, G.J., Maritnez, M.A., et al., 2001. Hopping Robot. US Patent 6247546.

[21]Stergiopulos, C., Vogt, D., Tolley, M.T., et al., 2014. A soft combustion-driven pump for soft robots. ASME Conference on Smart Materials, No. SMASIS2014-7536.

[22]Tiliakos, N., Tyll, J.S., Herdy, R., et al., 2001. Development and testing of a nitrous oxide/propane rocket engine. Joint Propulsion Conference and Exhibit, Paper No. AIAA-2001-3258. https://doi.org/10.2514/6.2001-3258

[23]Tolley, M.T., Shepherd, R.F., Karpelson, M., et al., 2014. An untethered jumping soft robot. IEEE/RSJ Intelligent Robots and Systems, p.561-566.

[24]Tsukagoshi, H., Sasaki, M., Kitagawa, A., et al., 2005. Design of a higher jumping rescue robot with the optimized pneumatic drive. IEEE International Conference on Robotics and Automation, p.1276-1283.

[25]Wang, H.M., Luan, Y.G., Zhang, K.T., 2012. A Gas Fuel-Powered Hopper. China Patent ZL 201010275632.0 (in Chinese).

[26]Wang, H.M., Luan, Y.G., Oetomo, D., et al., 2015. Design, analysis and experimental evaluation of a gas-fuel-powered hopper for robotic actuators. IEEE/ASME Transactions on Mechatronics, 20(5):2264-2275.

[27]Willhite, J.A., Yong, C., Barth, E.J., 2013. The high inertance free piston engine compressor—Part II: design and experimental evaluation. Journal of Dynamic Systems, Measurement, and Control, 135(4):041002.

[28]Zhao, J., Xu, J., Gao, B., et al., 2013. MSU jumper: a single-motor-actuated miniature steerable jumping robot. IEEE Transactions on Robotics, 29(3):602-614.